| Manuel Junyent has send me the following photo's with
his comments. He wants to use the tachometer for his lathe. He changed the
circuit a little to interface it to his sensor. Take a look:
Front view, working OK.
The schematic.
Artwork PCB.
The PCB before etching, the black spots are corrections (bad quality
photolithography)
Solder side, drilled and plated, ready to go!
Component side.
Component side, mounted and fully operational (without LCD) .
LCD and PIC pcb piggy backed together.
Rear view.
Sensor schematic
Sensor PCB
With Hall effect sensors
The support
The magnets
Installed
Final installation
Signals from sensor
Signal from sensor
Several views of my lathe without tachometer (yet).....!!
|
